![axson radio scrambler axson radio scrambler](https://images-cdn.dashdigital.com/dirtwheels/april_2020/data/articles/img/034.png)
Your circuit’s peak resonance is now set, and you may expect it to perform at its best.
![axson radio scrambler axson radio scrambler](https://i-sohoa.vnecdn.net/2017/12/19/DSCF0346-1513673128.jpg)
Connect a DC voltmeter with a range of 0 to 10 volts to the ground line and the point “test.”.The jammer could even jam beyond the VHF band or longwave band. Longer distances produce more MW noise however, VHF noise can be detected at 8-10 m. The jammer has a range of 10-15 meters, and the range can be extended by using a 6-8 m antenna. Because of the voltage drop caused by the antenna, the 8 mm spark length has been reduced to 2-3 mm. The spacing between the sparks is 2-3 mm.
#Axson radio scrambler driver#
Ensure the flyback & the driver are connected attach the antenna to the spark gap Many directions for making homemade flyback secondary coils may be found online. To get a higher voltage, connect two or three coils in series. The coil must be no more than 1 mm thick! In this case, instead of paraffin wax, use epoxy! Paraffin is easily melted. (It can be stretched to 20mm during operation.)īecause high secondary voltage can easily ruin the original coil, a homemade thin secondary is advised if you want to pump more watts into the flyback. The flyback requires a 20W power supply to operate and produces 8-9 mm sparks. Paraffin wax is used to impregnate the coil. The internal arc between the windings is avoided. The coil thickness is 1 mm, and the magnet wire is 0.1 mm (38 AWG). This way, the ultrasonic vibration is reduced. While setting up the flyback, remember to position the ferrite cores while ensuring the plastic plates are between them.
![axson radio scrambler axson radio scrambler](https://ae01.alicdn.com/kf/HTB1RnMnOpXXXXXWXFXXq6xXFXXXL/223509512/HTB1RnMnOpXXXXXWXFXXq6xXFXXXL.jpg)
After that, put in place the secondary and the new primary along with the feedback. Make a little hard paper cylinder and stick the primary and secondary coils to it by using glue. Take out the original main coil of the flyback.
![axson radio scrambler axson radio scrambler](https://images-cdn.dashdigital.com/dirtwheels/april_2020/data/articles/img/032.jpg)
#Axson radio scrambler tv#
You’ll need an antique black-and-white TV flyback transformer. The flyback primary and secondary are not soldered to the driver circuit instead, screws are used to secure them so that different flybacks can be mounted later. The driver is a prototype with a small heatsink, and the transistor heats up quickly. To protect the transistor from voltage spikes, a fast diode is advised. Wind the primary and feedback coils in the same direction. If you want to assemble a homemade RF signal jammer’s circuit, check out the 3 steps as demonstrated below: 1.
#Axson radio scrambler how to#
Guide on How to Make a Radio Frequency Jammer